#1 2022-06-13 21:50

thattguy
Member
Registered: 2021-03-31
Posts: 49

crack pipes

I was just wondering how you guys make pipes for using crack cocaine? I prefer glass pipes so i can see the residue to push, but im looking for a new glass tube to use

#2 2022-06-15 18:40

chitty
Member
Registered: 2022-02-12
Posts: 84

Re: crack pipes

wic ked habits on trademe or their site .co.nz sell "borosilicate" glass tubes

Last edited by chitty (2022-06-15 18:40)

#3 2022-06-18 19:10

JessiePinkman
Banned
Registered: 2022-06-10
Posts: 25

Re: crack pipes

The tubes wic ked habits sell are going to be a great starting point. Its been a while since I wielded a MAPP gas & torch combo, but I imagine it wouldn't be too difficult to narrow a section of the tube down to make it suitable for crack consumption.

Last edited by JessiePinkman (2022-06-18 19:10)

#4 2022-06-20 06:00

chitty
Member
Registered: 2022-02-12
Posts: 84

Re: crack pipes

What is this you say, how do you make your crack pipes? I was just putting a bit of metal scourer into the tube and using it like that, or is the thinner section to stop the metal scourer sliding around in the pipe or such (an occasional problem)?

#5 2022-09-29 21:00

thattguy
Member
Registered: 2021-03-31
Posts: 49

Re: crack pipes

chitty wrote:

wic ked habits on trademe or their site .co.nz sell "borosilicate" glass tubes

Iv picked one of these up for my next batch, but the glass is much thicker than i have used in the past. Do you normally use a blowtorch with these or just a plain old bic??

Board footer